Home › Engine / Hybrid System › 1VD-FTV (EMISSION CONTROL) › EXHAUST GAS TEMPERATURE SENSOR(for DPF) › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052786 1VD-FTV EMISSION CONTROL _0255154 EXHAUST GAS TEMPERATURE SENSOR(for DPF) A

1VD-FTV EMISSION CONTROL  EXHAUST GAS TEMPERATURE SENSOR(for DPF)  INSTALLATION  


PROCEDURE

Hide 89425B 1.INSTALL NO. 3 EXHAUST GAS TEMPERATURE SENSOR (for Bank 2)

NOTICE:

If the sensor is dropped, replace it with a new one.


a.

Using a 14 mm union nut wrench, install the No. 3 exhaust gas temperature sensor.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


HINT:

The identification tape on the exhaust gas temperature sensor is gray.



Hide 89425A 2.INSTALL NO. 2 EXHAUST GAS TEMPERATURE SENSOR (for Bank 1)

NOTICE:

If the sensor is dropped, replace it with a new one.


a.

Using a 14 mm union nut wrench, install the No. 2 exhaust gas temperature sensor.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


HINT:

The identification tape on the exhaust gas temperature sensor is white.



Hide 89425 3.INSTALL EXHAUST GAS TEMPERATURE SENSOR

NOTICE:

If the sensor is dropped, replace it with a new one.


a.

Using a 14 mm union nut wrench, install the 2 exhaust gas temperature sensors.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


HINT:

The identification tape on the exhaust gas temperature sensor is pink.



Hide 18460 4.INSTALL MONOLITHIC CONVERTER ASSEMBLY

Hide 89425C 5.INSTALL NO. 4 EXHAUST GAS TEMPERATURE SENSOR

NOTICE:

If the sensor is dropped, replace it with a new one.


a.

Using a 14 mm union nut wrench, install the 2 No. 4 exhaust gas temperature sensors.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


HINT:

The identification tape on the exhaust gas temperature sensor is gold.



Hide 17450B 6.INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY