Home › Engine / Hybrid System › 3UR-FE (EMISSION CONTROL) › EMISSION CONTROL SYSTEM(w/o Secondary Air Injection System)
RM2660E _51 Engine / Hybrid System _052787 3UR-FE EMISSION CONTROL _0255155 EMISSION CONTROL SYSTEM(w/o Secondary Air Injection System) G

3UR-FE EMISSION CONTROL  EMISSION CONTROL SYSTEM(w/o Secondary Air Injection System)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 25860 1.CHECK PURGE VSV

a.

Connect the intelligent tester to the DLC3.



c.
A243487

Disconnect the hose (connected to the canister) from the purge VSV.


d.

Start the engine and turn the intelligent tester main switch on.


e.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for Evap Control.

OK:
Tester Operation Specified Condition
Activate the VSV for Evap Control: OFF Purge VSV has no suction
Activate the VSV for Evap Control: ON Purge VSV has suction



f.

Connect the hose (connected to the canister) to the purge VSV.



Hide 2.INSPECT FUEL CUT-OFF RPM

a.

Start and warm up the engine.


b.

Open the throttle valve and keep the engine speed at 3000 rpm.


c.

Use a sound scope to check for injector operating noise.


d.

Check that when the accelerator pedal is released, the injector operation noise stops momentarily and then resumes.

If the result is as not specified, check the injector, wiring and ECM.


Hide 3.VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS

a.

Check that there are no cracks, leaks or damage.

HINT:

Separation of the engine oil dipstick, oil filler cap, ventilation hose, etc. may cause an engine failure or engine malfunctions. Disconnection, looseness or cracks in the parts of the air induction system between the throttle body and cylinder head will allow air suction and cause an engine failure or engine malfunctions.


NOTICE:
·

Detachment or other problems with the engine oil dipstick, filler cap, ventilation hose and other components may cause the engine to run improperly.

·

Disconnection, looseness or cracks in the parts of the air induction system between the throttle body and cylinder head will allow air suction and cause an engine failure or engine malfunctions.



If the result is not as specified, replace parts as necessary.


Hide 4.CHECK HOSES AND CONNECTORS

a.

Visually check for loose connections, sharp bends or damage.


Hide 5.CHECK FUEL TANK ASSEMBLY

a.

Visually check for deformation, cracks or fuel leakage.