Home › Engine / Hybrid System › 3UR-FE (INTAKE / EXHAUST) › EXHAUST PIPE
RM2660E _51 Engine / Hybrid System _052789 3UR-FE INTAKE / EXHAUST _0255169 EXHAUST PIPE A

3UR-FE INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Wear protective gloves when removing the exhaust pipe.

·

The exhaust pipe is extremely hot immediately after the engine has stopped.

·

Confirm that the exhaust pipe has cooled down before removing it.



PROCEDURE

Hide 17430 2.REMOVE TAILPIPE ASSEMBLY

a.

Remove the bolt, clamp and gasket.


b.

Remove the tailpipe from the 2 exhaust pipe supports.


c.

Remove the bolt and clamp, and then disconnect the tailpipe from the center exhaust pipe.


Hide 17581A 3.REMOVE EXHAUST PIPE DAMPER

a.
A175001

Remove the 2 bolts and exhaust pipe damper from the tailpipe.


Hide 17420 4.REMOVE CENTER EXHAUST PIPE ASSEMBLY

a.

Remove the 4 bolts.


b.

Remove the center exhaust pipe from the 3 exhaust pipe supports.


c.

Remove the 2 gaskets from the front exhaust pipe and front No. 2 exhaust pipe.


Hide 17450B 5.REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

a.

Disconnect the heated oxygen sensor connector.


b.

Remove the bolt and disconnect the wire harness clamp bracket of the oxygen sensor from the transmission.


c.

Remove the 2 nuts, front No. 2 exhaust pipe and gasket from the exhaust manifold LH.


Hide 17410 6.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.

Disconnect the heated oxygen sensor connector.


b.

Remove the bolt and disconnect the wire harness clamp bracket of the oxygen sensor from the transmission.


c.

Remove the 2 nuts, front exhaust pipe and gasket from the exhaust manifold RH.


Hide 89465A 7.REMOVE NO. 2 HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

Hide 89465 8.REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)