Home › Engine / Hybrid System › 1VD-FTV (INTAKE / EXHAUST) › SNORKEL AIR CLEANER
RM2660E _51 Engine / Hybrid System _052790 1VD-FTV INTAKE / EXHAUST _0255170 SNORKEL AIR CLEANER A

1VD-FTV INTAKE / EXHAUST  SNORKEL AIR CLEANER  INSTALLATION  


PROCEDURE

Hide 53709B 1.INSTALL INLET AIR CLEANER SEAL BRACKET SUB-ASSEMBLY

a.
A170262

Install the inlet air cleaner seal bracket with the 2 bolts.

Torque:
6.5 N*m (70 kgf*cm, 58 in.*lbf)


Hide 17752 2.INSTALL NO. 2 INLET AIR CLEANER

a.
A170261

Install the No. 2 inlet air cleaner with the 2 bolts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


Hide 17700 3.INSTALL AIR CLEANER ASSEMBLY

a.

Install the air cleaner case with the 3 bolts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


b.

Attach the wire harness clamp to the air cleaner case.


c.

Connect the mass air flow meter connector and attach the wire harness clamp to the air cleaner cap.


Hide 17751 4.INSTALL NO. 1 INLET AIR CLEANER

a.
A170263E01
1.042,0.434 1.381,0.575 0.338,0.141 10 Claw 1.858,1.344 1.618,0.527 1.618,0.527 1.485,0.527 false

Attach the claw of the No. 1 inlet air cleaner to the No. 2 inlet air cleaner, and install the No. 1 inlet air cleaner with the 2 bolts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


Hide 53875A 5.INSTALL FRONT FENDER LINER RH

a.

Install the fender liner with the 5 clips.


b.

Using a T30 "TORX" socket, install the 3 screws.


c.

Connect the liner to the front bumper cover with the screw.


Hide 53805 6.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 53295G 7.INSTALL COOL AIR INTAKE PIPE RETAINER

a.
A170259

Install the cool air intake pipe retainer with the 2 bolts.


Hide 53299B 8.INSTALL COOL AIR INTAKE DUCT

a.
A170258

Install the cool air intake duct with the 2 bolts.


Hide 17730 9.INSTALL AIR PRE-CLEANER ASSEMBLY

a.
A170264

Temporarily install the No. 2 inlet air cleaner bracket to the inlet air cleaner seal bracket with the bolt.


b.

Install the air pre-cleaner to the cool air intake duct.

HINT:

Fit the air pre-cleaner into the groove of the cool air intake duct with the side stamped "FRONT" facing forward.



c.
U164829E02
2.969,2.917 3.125,3.083 0.156,0.167 10 false A

Tighten the bolt of the inlet air cleaner bracket.

HINT:

When tightening bolt, make sure that the clearance labeled A in the illustration os as specified.


Standard clearance:

0 to 5 mm (0 to 1.97 in.)