Home › Engine / Hybrid System › 1VD-FTV (INTAKE / EXHAUST) › SNORKEL AIR CLEANER
RM2660E _51 Engine / Hybrid System _052790 1VD-FTV INTAKE / EXHAUST _0255170 SNORKEL AIR CLEANER A

1VD-FTV INTAKE / EXHAUST  SNORKEL AIR CLEANER  REMOVAL  


PROCEDURE

Hide 17730 1.REMOVE AIR PRE-CLEANER ASSEMBLY

a.
A170257

Remove the bolt, air pre-cleaner and No. 2 inlet air cleaner bracket.


Hide 53299B 2.REMOVE COOL AIR INTAKE DUCT

a.
A170258

Remove the 2 bolts and cool air intake duct.


Hide 53295G 3.REMOVE COOL AIR INTAKE PIPE RETAINER

a.
A170259

Remove the 2 bolts and cool air intake pipe retainer.


Hide 53805 4.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 53875A 5.REMOVE FRONT FENDER LINER RH

a.

Remove the screw and disconnect the liner from the front bumper cover.


b.

Using a T30 "TORX" socket, remove the 3 screws.


c.

Remove the 5 clips.

HINT:

It is not necessary to fully remove the fender liner. Partially remove it so that the air pump can be removed.



Hide 17751 6.REMOVE NO. 1 INLET AIR CLEANER

a.
A170260

Remove the 2 bolts.


b.

Detach the claw shown in the illustration, and then remove the No. 1 inlet air cleaner.


Hide 17700 7.REMOVE AIR CLEANER ASSEMBLY

a.

Disconnect the mass air flow meter connector and using a clip remover, detach the wire harness clamp from the air cleaner cap.


b.

Using a clip remover, detach the wire harness clamp from the air cleaner case.


c.

Remove the 3 bolts and air cleaner case.


Hide 17752 8.REMOVE NO. 2 INLET AIR CLEANER

a.
A170261

Remove the 2 bolts and inlet air cleaner.


Hide 53709B 9.REMOVE INLET AIR CLEANER SEAL BRACKET SUB-ASSEMBLY

a.
A170262

Remove the 2 bolts and inlet air cleaner seal bracket.