Wear protective gloves and protective glasses when removing the exhaust pipe.
The exhaust pipe is extremely hot immediately after the engine has stopped.
Confirm that the exhaust pipe has cooled down before removing it.
89467B
1.REMOVE AIR FUEL RATIO SENSOR
53784
2.REMOVE FRONT FENDER APRON SEAL REAR RH
53785B
3.REMOVE FRONT FENDER APRON SEAL REAR LH
51442
4.REMOVE NO. 2 ENGINE UNDER COVER
Remove the 6 bolts and No. 2 engine under cover.
17430
5.REMOVE TAILPIPE ASSEMBLY
Remove the bolt, clamp and gasket.
Disconnect the tailpipe from the 2 exhaust pipe supports.
17420
6.REMOVE CENTER EXHAUST PIPE ASSEMBLY
Remove the 4 bolts and 2 compression springs.
Disconnect the center exhaust pipe from the 3 exhaust pipe supports.
Remove the gasket from the No. 5 exhaust pipe and front exhaust pipe.
17410
7.REMOVE FRONT EXHAUST PIPE ASSEMBLY
Disconnect the 2 air hoses.
Disconnect the exhaust gas temperature sensor connector and detach the clamp.
Remove the 3 nuts and front exhaust pipe.
Remove the gasket.
17450
8.REMOVE NO. 5 EXHAUST PIPE ASSEMBLY
Remove the 2 nuts and No. 5 exhaust pipe.
Remove the gasket.
17450B
9.REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY
Disconnect the 2 air hoses.
Disconnect the exhaust gas temperature sensor connector and detach the clamp.
Remove the 3 nuts and front No. 2 exhaust pipe.
Remove the gasket.
89425C
10.REMOVE NO. 4 EXHAUST GAS TEMPERATURE SENSOR
18450A
11.REMOVE MONOLITHIC CONVERTER ASSEMBLY RH
Disconnect the 2 exhaust gas temperature sensor connectors and detach the 4 clamps.
Remove the 3 bolts and manifold stay.
Remove the 3 nuts and monolithic converter RH.
Remove the gasket from the turbocharger.
37140
12.REMOVE FRONT PROPELLER SHAFT ASSEMBLY
18460
13.REMOVE MONOLITHIC CONVERTER ASSEMBLY LH
Disconnect the 2 exhaust gas temperature sensor connectors and detach the 4 clamps.
Remove the 3 bolts and No. 2 manifold stay.
Remove the 3 nuts and monolithic converter LH.
Remove the gasket from the turbocharger.
89425B
14.REMOVE NO. 3 EXHAUST GAS TEMPERATURE SENSOR
89425A
15.REMOVE NO. 2 EXHAUST GAS TEMPERATURE SENSOR
89425
16.REMOVE EXHAUST GAS TEMPERATURE SENSOR