1.DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
53806
4.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
53805
5.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
51405A
6.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
7.DRAIN ENGINE COOLANT
11259
8.REMOVE V-BANK COVER
Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
| *1 | Pin |
| *2 | Hook |
17881
9.REMOVE NO. 1 AIR CLEANER HOSE
Disconnect the No. 2 PCV hose and vacuum hose.
Remove the bolt and loosen the 2 hose clamps.
Remove the No. 1 air cleaner hose.
17361
10.REMOVE AIR TUBE (w/ Secondary Air Injection System)
Disconnect the No. 3 air hose.
for Bank 1 Side:
Remove the bolt and disconnect the air tube assembly from the emission control valve set.
for Bank 2 Side:
Remove the 2 bolts and disconnect the air tube assembly from the No. 2 emission control valve set.
17129
11.REMOVE INTAKE AIR SURGE TANK
Disconnect the throttle body connector.
Disconnect the No. 4 water by-pass hose.
Disconnect the No. 5 water by-pass hose.
Disconnect the purge line hose.
Disconnect the No. 1 vacuum switching valve connector.
Disconnect the No. 1 PCV hose.
Remove the 2 bolts and throttle body bracket.
Detach the 2 wire harness clamps and remove the bolt and bracket.
Detach the wire harness clamp.
Remove the 2 bolts and No. 1 surge tank stay.
for Manual Transmission:
Remove the nut and disconnect the clutch flexible hose bracket.
Remove the 2 bolts and No. 2 surge tank stay.
Remove the 2 nuts, 4 bolts and intake air surge tank.
Remove the gasket.
23807
12.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY
17111
13.REMOVE INTAKE MANIFOLD
Remove the 4 nuts, 6 bolts and 2 gaskets.
14.REMOVE STUD BOLT
If a stud bolt is deformed or its threads are damaged, replace it.