Home › Engine / Hybrid System › 1GR-FE (LUBRICATION) › OIL PRESSURE SENSOR
RM2660E _51 Engine / Hybrid System _052798 1GR-FE LUBRICATION _0255218 OIL PRESSURE SENSOR A

1GR-FE LUBRICATION  OIL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 83520 1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

Apply adhesive to 2 or 3 threads of the oil pressure switch.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:

Do not apply adhesive to the oil inlet port of the oil pressure switch.



b.

Install the oil pressure switch.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine within 1 hour of installation.



c.

Connect the oil pressure switch connector.


Hide 51405A 3.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 53806 4.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 53805 5.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH