Home › Engine / Hybrid System › 1GR-FE (STARTING) › STARTER › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052800 1GR-FE STARTING _0255230 STARTER A

1GR-FE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 17105 3.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH

Hide 28192 4.REMOVE STARTER COVER

a.
A264673

Remove the 3 bolts and starter cover.


Hide 28100 5.REMOVE STARTER ASSEMBLY

a.
A264674

Remove the bolt and disconnect the ground wire.


b.

Disconnect the starter connector.


c.

Disconnect the terminal cap.


d.

Remove the nut and disconnect the starter wire.


e.

Remove the 2 bolts and starter.


Hide 11363A 6.REMOVE FLYWHEEL HOUSING SIDE COVER

A222907