1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
17105
3.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH
28192
4.REMOVE STARTER COVER
Remove the 3 bolts and starter cover.
28100
5.REMOVE STARTER ASSEMBLY
Remove the bolt and disconnect the ground wire.
Disconnect the starter connector.
Disconnect the terminal cap.
Remove the nut and disconnect the starter wire.
Remove the 2 bolts and starter.
11363A
6.REMOVE FLYWHEEL HOUSING SIDE COVER