Home › Engine / Hybrid System › 1VD-FTV (STARTING) › GLOW PLUG › from 2015.08
RM2660E _51 Engine / Hybrid System _052803 1VD-FTV STARTING _0255242 GLOW PLUG A

1VD-FTV STARTING  GLOW PLUG  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing an injector (including interchanging injectors between cylinders) or common rail, replace the corresponding injection pipes with new ones.

·

w/ DPF

When fuel lines are disconnected, air may enter the fuel lines, leading to engine starting trouble. Therefore, perform forced regeneration and bleed the air from the fuel lines (See page Engine / Hybrid System>1VD-FTV (EMISSION CONTROL)>EMISSION CONTROL SYSTEM>ON-VEHICLE INSPECTION).



PROCEDURE

Hide 19850 1.INSTALL GLOW PLUG ASSEMBLY

a.

Clean the glow plug and glow plug hole.


b.
A263013E02
0.934,1.385 1.117,1.536 0.183,0.151 10 *a

Apply adhesive to 3 or more thread roots in the area shown in the illustration.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent


Text in Illustration
*a 12 Thread Roots


c.

Using a 10 mm deep socket wrench, install the 8 glow plugs.

Torque:
12 N*m (125 kgf*cm, 9 ft.*lbf)


Hide 19871 2.INSTALL NO. 1 GLOW PLUG CONNECTOR

a.

Install the 2 glow plug connectors by uniformly tightening the 8 nuts.

Torque:
2.2 N*m (22 kgf*cm, 19 in.*lbf)


b.

Install the 8 screw grommets.


c.

Connect the 2 wire harnesses with the 2 nuts and 2 screw grommets.

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


Hide 17940D 4.INSTALL INTERCOOLER ASSEMBLY (w/ Intercooler)

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).