19850
1.CHECK GLOW PLUG ASSEMBLY
Remove the glow plug connector (See page Engine / Hybrid System>1VD-FTV (STARTING)>GLOW PLUG>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Item | Tester Connection | Condition | Specified Condition |
|---|---|---|---|
| w/ DPF | Glow plug terminal - Body ground | 20°C (68°F) | 0.7 Ω or higher |
| w/o DPF | Approximately 1 Ω |
Be careful not to damage the glow plug, as this may cause an open circuit or shorten the life of the glow plugs.
Do not allow oil or gasoline to contact the glow plug when cleaning it.
Clean any oil on the terminal and bakelite washer with a dry cloth.
Do not apply more than 11 V to the glow plug, as this may cause an open circuit.
If the result is not as specified, replace the glow plug assembly.
Install the glow plug connector (See page Engine / Hybrid System>1VD-FTV (STARTING)>GLOW PLUG>INSTALLATION).