When replacing an injector (including interchanging injectors between cylinders) or common rail, replace the corresponding injection pipes with new ones.
w/ DPF
When fuel lines are disconnected, air may enter the fuel lines, leading to engine starting trouble. Therefore, perform forced regeneration and bleed the air from the fuel lines (See page Engine / Hybrid System>1VD-FTV (EMISSION CONTROL)>EMISSION CONTROL SYSTEM>ON-VEHICLE INSPECTION).
28100
1.INSTALL STARTER ASSEMBLY
Install the starter with the 2 bolts.
Connect the 2 starter hoses.
| *1 | Yellow Mark |
Attach the harness clamp and connect the wire harness.
Connect the starter wire with the nut.
Connect the starter connector.
25689
2.INSTALL EGR COOLER INSULATOR (w/ EGR System)
23920A
3.INSTALL FUEL COOLER ASSEMBLY (w/o DPF)
25620
4.INSTALL EGR VALVE ASSEMBLY (w/ DPF)
28800
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).