Home › Engine / Hybrid System › 1VD-FTV (STARTING) › STARTER › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052803 1VD-FTV STARTING _0255243 STARTER A

1VD-FTV STARTING  STARTER  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing an injector (including interchanging injectors between cylinders) or common rail, replace the corresponding injection pipes with new ones.

·

w/DPF

When fuel lines are disconnected, air may enter the fuel lines, leading to engine starting trouble. Therefore, perform forced regeneration and bleed the air from the fuel lines.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 28800 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 25620 3.REMOVE EGR VALVE ASSEMBLY (w/ DPF)

Hide 23920A 4.REMOVE FUEL COOLER ASSEMBLY (w/o DPF)

Hide 25689 5.REMOVE EGR COOLER INSULATOR (w/ EGR System)

Hide 28100 6.REMOVE STARTER ASSEMBLY

a.
A269804

Detach the harness clamp and disconnect the wire harness.


b.

Disconnect the starter connector.


c.

Remove the nut and disconnect the starter wire.


d.
A269805

Disconnect the 2 starter hoses.


e.
A269806

Remove the 2 bolts and starter.