Use the same procedures for LHD and RHD vehicles.
The procedures listed below are for LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
45130
3.REMOVE STEERING PAD
84632
4.REMOVE CRUISE CONTROL MAIN SWITCH
Disconnect the connector.
| *a | Screw |
| *b | Connector |
Remove the 2 screws.
Disconnect the connector and remove the cruise control main switch wire.