Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255249 CRUISE CONTROL SYSTEM C

CRUISE CONTROL  CRUISE CONTROL SYSTEM  P0503  Vehicle Speed Sensor "A" Intermittent / Erratic / High  


DESCRIPTION

If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the master cylinder solenoid (skid control ECU) is detected while the cruise control is in operation, the ECM determines there to be a momentary interruption and noise, and outputs a DTC.

DTC Code DTC Detection Condition Trouble Area
P0503 A momentary interruption and noise are detected when a rapid change of the vehicle speed occurs while the cruise control is in operation.
·

Vehicle speed sensor

·

Vehicle speed sensor signal circuit

·

ECM

·

Combination meter



CAUTION / NOTICE / HINT

This DTC code may be output under the vehicle stability control system at the same time. In that case, perform troubleshooting for the vehicle stability control system first.

PROCEDURE

1.CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM OR ANTI-LOCK BRAKE SYSTEM)
a.

Using the intelligent tester, enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Code.


b.

Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
OK
(DTC is not output)
A
NG
(for Vehicle Stability Control System)
B
NG
(for Anti-lock Brake System)
C



A

2.CHECK DTC (CRUISE CONTROL SYSTEM)

B

C

2.CHECK DTC (CRUISE CONTROL SYSTEM)
a.

Using the intelligent tester, enter the following menus: Powertrain / Cruise Control / Trouble Code.



c.

Perform the following to make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.


i.

Drive the vehicle at a speed of 45 km/h (28 mph) or more.


ii.

Turn the cruise control main switch on.


iii.

Push the -SET switch to activate the cruise control.



d.

Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
OK
(DTC P0503 is not output)
A
NG
(for 1GR-FE)
B
NG
(for 1UR-FE)
C
NG
(for 3UR-FE)
D
NG
(for 1VD-FTV)
E



A

B

C

D

E