Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255249 CRUISE CONTROL SYSTEM C

CRUISE CONTROL  CRUISE CONTROL SYSTEM  P0575  Cruise Control Input Circuit  P0607  Control Module Performance  


DESCRIPTION

This DTC indicates the internal abnormalities of the ECM.

DTC Code DTC Detection Condition Trouble Area
P0575 When either of the following conditions is met:
·

STP signals input to the ECM supervisory CPU and control ECU are different for 0.15 seconds or more.

·

0.4 seconds have passed after cruise cancel input signal (STP input) is input to the ECM.


ECM (for 1GR-FE, 1UR-FE, 3UR-FE)
P0607 When the cruise control main switch is turned off, the ECM recognizes that the cruise control system is operating. ECM (for 1VD-FTV, w/o DPF)

HINT:

The ECM receives signals from each sensor to control all functions of the cruise control system. When this trouble code is stored, fail-safe remains on until the ignition switch is turned off.


PROCEDURE

1.CHECK DTC (CRUISE CONTROL SYSTEM)
a.

Using the intelligent tester, enter the following menus: Powertrain / Cruise Control / Trouble Code.



c.

Recheck for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
OK
(DTC is not output)
A
NG
(DTC P0575 is output for 1GR-FE)
B
NG
(DTC P0575 is output for 1UR-FE)
C
NG
(DTC P0575 is output for 3UR-FE)
D
NG
(DTC P0607 is output for 1VD-FTV, w/o DPF)
E



A

B

C

D

E