Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › from 2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255249 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Cruise SET Indicator Light Circuit  


DESCRIPTION

·

The ECM turns on the cruise control SET indicator by sending indicator output demand signals to the combination meter assembly using CAN communication.

·

The cruise control SET indicator illuminates when the cruise control system is controlling vehicle speed.

·

The cruise control SET indicator circuit uses CAN communication. If the cruise control SET indicator is not functioning correctly, check for CAN communication system before troubleshooting this circuit.


CAUTION / NOTICE / HINT

NOTICE:

When replacing the combination meter assembly, make sure to replace it with a new one.


PROCEDURE

1.PERFORM ACTIVE TEST USING GTS (INDICAT. SET)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Indicat. SET SET indicator light ON or OFF -

OK:

Cruise control SET indicator turns ON/OFF.




OK

2.READ VALUE USING GTS (-SET SWITCH)

NG

2.READ VALUE USING GTS (-SET SWITCH)
a.

Enter the following menus: Powertrain / Cruise Control / Data List.


b.

Read the Data List according to the display on the GTS.

Cruise Control
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
-SET Switch -/SET switch status / ON or OFF ON: -/SET switch on
OFF: -/SET switch off
-

Result:
Result Proceed to
The cruise control SET indicator illuminates and turns off according to the operation of the cruise control main switch (-/SET switch). A
The cruise control SET indicator does not illuminate but the Data List item -SET Switch changes according to the operation of the cruise control main switch (-/SET switch). B
The cruise control SET indicator does not illuminate and the Data List item -SET Switch does not change according to the operation of the cruise control main switch (-/SET switch). C


HINT:
Refer to the ECM removal procedures:
Item See page
1GR-FE (Click here)
1UR-FE (Click here)
3UR-FE (Click here)
1VD-FTV (Click here)




A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY

C

REPLACE ECM