Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER › from 2015.08
RM2660E _58 Vehicle Interior _052841 METER / GAUGE / DISPLAY _0255599 COMBINATION METER A

METER / GAUGE / DISPLAY  COMBINATION METER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.DISABLE AUTOAWAY/RETURN FUNCTION (for Power Tilt and Power Telescopic Steering Column)

a.

Disable the autoaway/return function by changing the customize parameter (See page Steering>STEERING COLUMN>POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM>CUSTOMIZE PARAMETERS).

CAUTION:

Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.


HINT:

Performing the above operation causes the autoaway/return function to be disabled when the engine switch is turned off.



b.

Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.


c.

Turn the ignition switch off.


Hide 55449C 2.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

Hide 55403C 3.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

Hide 55474C 4.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55475A 5.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55404C 6.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

U156852E01
0.819,0.055 1.011,0.234 0.192,0.179 10 *a 1.044,0.449 0.944,0.247 false

a.

Put protective tape around the No. 2 instrument cluster finish panel sub-assembly.

Text in Illustration
*a Protective Tape


b.
E337027

Detach the 4 claws.


c.
E337028

Detach the 9 claws.


d.

Disconnect the connectors and remove the No. 2 instrument cluster finish panel sub-assembly.


Hide 83100 7.REMOVE COMBINATION METER ASSEMBLY

E337029

a.

Remove the 4 screws.


b.

Disconnect the connectors and remove the combination meter assembly.