This DTC is output when the brake control system has a problem. Check the brake control system when this DTC is output.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P1578 | The ECM receives a brake system error signal for 0.2 sec. or more while the cruise control is operating. | ·
Vehicle stability control system*1 ·
Anti-lock brake system*2 ·
Skid control ECU (master cylinder solenoid) ·
ECM |
w/ Vehicle Stability Control System
w/o Vehicle Stability Control System
This circuit uses CAN communication. Therefore, if there are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.
Check for DTCs.
w/ Vehicle Stability Control System: See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
w/o Vehicle Stability Control System: See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output (w/ Vehicle Stability Control System) | B |
| DTC is output (w/o Vehicle Stability Control System) | C |
A
B
C
Clear for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
Perform the following to make sure that the DTC detection conditions are met.
If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control system on using the cruise control main switch (ON/OFF).
Push the cruise control main switch to -/SET to begin control of vehicle speed by the cruise control system.
Enter the following menus: Powertrain / Cruise Control / Trouble Codes.
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC P1578 is output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
Replace the skid control ECU (master cylinder solenoid).
for LHD: See page Brake>BRAKE SYSTEM (OTHER)>HYDRAULIC BRAKE BOOSTER(for LHD)>DISASSEMBLY
for RHD: See page Brake>BRAKE SYSTEM (OTHER)>HYDRAULIC BRAKE BOOSTER(for RHD)>DISASSEMBLY
NEXT
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
Perform the following to make sure that the DTC detection conditions are met.
If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control system on using the cruise control main switch (ON/OFF).
Push the cruise control main switch to -/SET to begin control of vehicle speed by the cruise control system.
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC P1578 is output (for 1GR-FE) | B |
| DTC P1578 is output (for 1VD-FTV) | C |
| DTC P1578 is output (for 1UR-FE) | D |
| DTC P1578 is output (for 3UR-FE) | E |
A
B
C
D
E