Home › Engine / Hybrid System › CRUISE CONTROL › CLUTCH SWITCH(for LHD)
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255250 CLUTCH SWITCH(for LHD) A

CRUISE CONTROL  CLUTCH SWITCH(for LHD)  INSTALLATION  


PROCEDURE

Hide 88280A 1.INSTALL CLUTCH SWITCH ASSEMBLY

a.
B181125

Install the clutch switch assembly and tighten the adjusting nut.

Torque:
16 N*m (163 kgf*cm, 12 ft.*lbf)


b.
B186774E01
2.253,1.335 2.828,1.551 0.575,0.217 10 Cushion 1.652,1.664 1.829,1.41 1.829,1.41 2.226,1.41 false 1.669,1.281 1.976,0.8 1.976,0.8 2.148,0.8 false 2.174,0.749 3.165,0.996 0.991,0.246 10 Adjusting Nut

Adjust the clutch switch so that the threaded portion of the clutch switch lightly contacts the cushion. Then tighten the adjusting nut and check the contact of the cushion and switch.

Torque:
16 N*m (163 kgf*cm, 12 ft.*lbf)

NOTICE:

After adjusting the pedal free play, perform the clutch switch assembly adjustment (See page Drivetrain>CLUTCH>CLUTCH PEDAL(for LHD)>ADJUSTMENT).



Hide 55107A 2.INSTALL CLUTCH PEDAL SUPPORT SUB-ASSEMBLY WITH CLUTCH MASTER CYLINDER

a.

Install the clutch pedal support sub-assembly with clutch master cylinder (See page Drivetrain>CLUTCH>CLUTCH PEDAL(for LHD)>INSTALLATION).