The ECM turns on the cruise control indicator by sending indicator output demand signals to the combination meter assembly using CAN communication.
The cruise control indicator illuminates when the cruise control system has been turned on using the ON/OFF button. If a malfunction is detected, the cruise control indicator goes out and a warning message is displayed.
The cruise control indicator circuit uses CAN communication. If the cruise control indicator is not functioning correctly, check for CAN communication system before troubleshooting this circuit.
When replacing the combination meter assembly, make sure to replace it with a new one.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Indicat. Lamp Cruise | Cruise control indicator | ON or OFF | - |
| Radar Cruise Indicator | Radar cruise control indicator | ON or OFF | - |
Cruise control indicator and Radar Cruise Indicator turns ON/OFF.
OK
NG
(See pageVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Enter the following menus: Powertrain / Radar Cruise1 / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Cruise Indicator | Cruise control indicator status / ON or OFF | ON: Cruise control indicator illuminates
OFF: Cruise control indicator turns off |
- |
| Result | Proceed to |
|---|---|
| The cruise control indicator illuminates and turns off according to the operation of the cruise control main switch (ON/OFF). | A |
| The cruise control indicator does not illuminate but the Data List item Cruise Indicator changes according to the operation of the cruise control main switch (ON/OFF). | B |
| The cruise control indicator does not illuminate and the Data List item Cruise Indicator does not change according to the operation of the cruise control main switch (ON/OFF) (for 1UR-FE). | C |
| The cruise control indicator does not illuminate and the Data List item Cruise Indicator does not change according to the operation of the cruise control main switch (ON/OFF) (for 3UR-FE). | D |
| The cruise control indicator does not illuminate and the Data List item Cruise Indicator does not change according to the operation of the cruise control main switch (ON/OFF) (for 1VD-FTV). | E |
A
(See pageEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE)
B
C
D
E