Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255251 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1578  Brake System Malfunction  


DESCRIPTION

This DTC may also be stored when there is a vehicle stability control system malfunction.

DTC Code DTC Detection Condition Trouble Area
P1578 During cruise control operation (vehicle-to-vehicle distance control mode), the brake system malfunctions.
·

Vehicle stability control system

·

ECM



CAUTION / NOTICE / HINT

NOTICE:

This DTC code may be output under the vehicle stability control system at the same time. In that case, perform troubleshooting for the vehicle stability control system first.


PROCEDURE

1.CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
a.

Using the intelligent tester, enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Code.




OK

2.CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)

NG

2.CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)
a.

Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / Trouble Code.



c.

Perform the following to make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.


i.

Drive the vehicle at a speed of 50 km/h (30 mph) or more.


ii.

Turn the cruise control main switch on.


iii.

Push the -SET switch to activate the dynamic radar cruise control.



d.

Result
Result Proceed to
OK A
NG (for 1UR-FE) B
NG (for 3UR-FE) C


A

B

C