This DTC indicates internal abnormalities of the ECM.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0575 | When either of the following conditions is met:
·
STP signals input to the ECM supervisory CPU and control ECU are different for 0.15 seconds or more. ·
0.4 seconds have passed after the cruise cancel input signal (STP input) is input to the ECM. |
ECM |
If DTC P0575 is stored while the dynamic radar cruise control is in operation, the master cylinder solenoid (skid control ECU) clears the stored vehicle speed in the ECM and cancels the dynamic radar cruise control operation. At the same time, the cruise control indicator light blinks to inform the driver of the malfunction. When this trouble code is stored, fail-safe remains on until the engine switch is turned off.
Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / Trouble Code.
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
DTC P0575 is not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 1UR-FE) | B |
| NG (for 3UR-FE) | C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C