Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255251 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  C1A52  Driving Support ECU Communication Abnormal  


DESCRIPTION

DTC C1A52 is stored when the ECM cannot recognize the driving support ECU assembly.

DTC No. DTC Detection Condition Trouble Area
C1A52 Approximately 17 seconds after the engine switch is turned on (IG), the ECM cannot recognize the driving support ECU assembly for approximately 1.3 seconds or more.
·

ECM

·

Driving support ECU assembly



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.

·

First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).



PROCEDURE

1.CHECK FOR DTCs (RADAR CRUISE2)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).



d.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

·

Turn the engine switch on (IG) and wait approximately 20 seconds or more.




e.

Enter the following menus: Powertrain / Radar Cruise2 / Trouble Codes.


f.

Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC C1A52 is output A
DTC C1A52 is not output B




A

2.REPLACE ECM

B

USE SIMULATION METHOD TO CHECK

2.REPLACE ECM

NEXT

3.CHECK FOR DTCs (RADAR CRUISE2)
3.CHECK FOR DTCs (RADAR CRUISE2)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).



d.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

·

Turn the engine switch on (IG) and wait approximately 20 seconds or more.




e.

Enter the following menus: Powertrain / Radar Cruise2 / Trouble Codes.


f.

Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC C1A52 is output A
DTC C1A52 is not output B




A

REPLACE DRIVING SUPPORT ECU ASSEMBLY

B

END (ECM WAS DEFECTIVE)