Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255251 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1630  Communication Error from VSC to ECM  


DESCRIPTION

The skid control ECU (master cylinder solenoid) sends signals such as cruise control cancel signals and brake demand response signals to the ECM when the dynamic radar cruise control system is operating.

DTC No. DTC Detection Condition Trouble Area
P1630 While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, communication data from the skid control ECU (master cylinder solenoid) is logically inconsistent for 0.5 seconds or more.
·

Communication circuit

·

Skid control ECU (master cylinder solenoid)

·

ECM



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Using the GTS, check that the CAN communication system is functioning normally.

OK:

CAN communication system is functioning normally.


HINT:

Refer to CAN Bus Check for the CAN communication system.



Result:
Result Proceed to
OK A
NG (for LHD) B
NG (for RHD) C




A

2.CHECK DTC (RADAR CRUISE1)

B

C

2.CHECK DTC (RADAR CRUISE1)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).



d.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

1.

Turn the engine switch on (IG).

2.

Turn the dynamic radar cruise control system on using the cruise control main switch (ON/OFF).

3.

Drive the vehicle at 5 km/h (3 mph) or more for 0.5 seconds or more.




e.

Enter the following menus: Powertrain / Radar Cruise1 / Trouble Codes.


f.

Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC P1630 is not output A
DTC P1630 is output B




A

B

3.REPLACE SKID CONTROL ECU (MASTER CYLINDER SOLENOID)
3.REPLACE SKID CONTROL ECU (MASTER CYLINDER SOLENOID)
a.

Replace the skid control ECU (master cylinder solenoid).




NEXT

4.CHECK FOR DTCs (RADAR CRUISE1)
4.CHECK FOR DTCs (RADAR CRUISE1)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).



d.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

1.

Turn the engine switch on (IG).

2.

Turn the dynamic radar cruise control system on using the cruise control main switch (ON/OFF).

3.

Drive the vehicle at 5 km/h (3 mph) or more for 0.5 seconds or more.




e.

Enter the following menus: Powertrain / Radar Cruise1 / Trouble Codes.


f.

Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC P1630 is not output A
DTC P1630 is output (for 1UR-FE) B
DTC P1630 is output (for 3UR-FE) C
DTC P1630 is output (for 1VD-FTV) D




A

END

B

C

D