Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255251 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1631  Communication Error from ECM to VSC  


DESCRIPTION

The ECM sends signals such as A/T information signals, dynamic radar cruise control operation signals and brake operation demand signals to the skid control ECU (master cylinder solenoid) when the dynamic radar cruise control is operating. The ECM is the only component that has a function to store and output DTCs in the dynamic radar cruise control system. Therefore, if the skid control ECU (master cylinder solenoid) detects a communication error from the ECM, it sends a malfunction signal back to the ECM.

DTC No. DTC Detection Condition Trouble Area
P1631 While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, the ECM continuously receives a logical error signal from the skid control ECU (master cylinder solenoid) for 1 second or more.
·

CAN communication system

·

ECM

·

Skid control ECU (master cylinder solenoid)



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Using the GTS, check that the CAN communication system is functioning normally.

OK:

CAN communication system is functioning normally.


HINT:

Refer to CAN Bus Check for the CAN communication system.



Result:
Result Proceed to
OK A
NG (for LHD) B
NG (for RHD) C




A

2.CHECK FOR DTCs (RADAR CRUISE1)

B

C

2.CHECK FOR DTCs (RADAR CRUISE1)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).



d.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

1.

Turn the engine switch on (IG).

2.

Turn the dynamic radar cruise control system on using the cruise control main switch (ON/OFF).

3.

Drive the vehicle at 5 km/h (3 mph) or more for 0.5 seconds or more.




e.

Enter the following menus: Powertrain / Radar Cruise1 / Trouble Codes.


f.

Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC P1631 is not output A
DTC P1631 is output B




A

B

3.REPLACE ECM
3.REPLACE ECM

NEXT

4.CHECK FOR DTCs (RADAR CRUISE1)
4.CHECK FOR DTCs (RADAR CRUISE1)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).



d.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

1.

Turn the engine switch on (IG).

2.

Turn the dynamic radar cruise control system on using the cruise control main switch (ON/OFF).

3.

Drive the vehicle at 5 km/h (3 mph) or more for 0.5 seconds or more.




e.

Enter the following menus: Powertrain / Radar Cruise1 / Trouble Codes.


f.

Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC P1631 is not output A
DTC P1631 is output (for LHD) B
DTC P1631 is output (for RHD) C




A

END

B

C