Home › Engine / Hybrid System › CRUISE CONTROL › FORWARD RECOGNITION CAMERA SYSTEM › from 2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255256 FORWARD RECOGNITION CAMERA SYSTEM T

CRUISE CONTROL  FORWARD RECOGNITION CAMERA SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

The forward recognition camera is used by multiple systems. If any malfunctions occur, refer to Problem Symptoms Table of each system.

- Dynamic radar cruise control system: (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE)

- Pre-collision system: (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>PROBLEM SYMPTOMS TABLE)

- Lane departure alert system: (See page Engine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>PROBLEM SYMPTOMS TABLE)

- Automatic high beam system: (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>PROBLEM SYMPTOMS TABLE)

·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Front Recognition Camera System
Symptom Suspected Area See page
The message "Forward Camera System Unavailable Clean Windshield" is frequently displayed Non-Toyota genuine front wiper blades are installed -
The front wiper rubbers are worn -
A sticker, accessory or other object is obstructing the forward recognition camera -
There is snow, frost, dirt, dust or oil on the windshield glass, or the windshield glass is fogged up -
A glass coating has been applied to the windshield glass -
The windshield glass is chipped or cracked -
Non-Toyota genuine windshield glass is installed -
The forward recognition camera is malfunctioning (Click here)
The message "Forward Camera System Unavailable" is frequently displayed Immediately after the engine is started -
The cabin temperature is extremely high -
The cabin temperature is extremely low -
The forward recognition camera is malfunctioning (Click here)
A system that uses the forward recognition camera does not operate The power source circuit is malfunctioning (Click here)
The forward recognition camera is malfunctioning (Click here)