Home › Engine / Hybrid System › CRUISE CONTROL › FORWARD RECOGNITION CAMERA SYSTEM › from 2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255256 FORWARD RECOGNITION CAMERA SYSTEM J

CRUISE CONTROL  FORWARD RECOGNITION CAMERA SYSTEM  Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the forward recognition camera.

WIRING DIAGRAM

E256368E56
0.385,0.896 1.813,1.146 1.427,0.25 10 false from IG Circuit 2.667,1.063 3.76,1.292 1.094,0.229 10 false ECU-IG NO. 2 5.292,0.917 5.75,1.115 0.458,0.198 10 false IGB 5.281,1.938 5.74,2.135 0.458,0.198 10 false GND 5.052,1.833 5.292,2.021 0.24,0.188 10 false 10 5.115,0.802 5.229,1.01 0.115,0.208 10 false 7 4.792,2.656 6.646,2.865 1.854,0.208 10 false Forward Recognition Camera 4.781,2.49 5.24,2.688 0.458,0.198 10 false R20

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (POWER SOURCE VOLTAGE)
a.

Disconnect the R20 forward recognition camera connector.


b.

Turn the engine switch on (IG).


c.
U166382E02
1.271,1.385 0.969,1.75 false 0.594,1.188 0.948,1.375 0.354,0.188 10 false R20 0.708,1.719 1.021,1.938 0.313,0.219 10 false IGB 0.198,0.021 0.396,0.219 0.198,0.198 10 false *a

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Condition
R20-7 (IGB) - Body ground Engine switch on (IG) 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Forward Recognition Camera)



OK

2.CHECK HARNESS AND CONNECTOR (FORWARD RECOGNITION CAMERA - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (FORWARD RECOGNITION CAMERA - BODY GROUND)
a.

Disconnect the R20 forward recognition camera connector.


b.
U166383E02
1.792,1.427 2.104,1.792 true 0.604,1.188 0.958,1.417 0.354,0.229 10 false R20 2.146,1.74 2.51,1.958 0.365,0.219 10 false GND 0.198,0.021 0.396,0.219 0.198,0.198 10 false *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Condition
R20-10 (GND) - Body ground Always Below 1 Ω


Text in Illustration
*a Front view of wire harness connector
(to Forward Recognition Camera)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR