Shifting from 1st to 6th is performed in combination with ON and OFF operation of the shift solenoid valves SL1, SL2, S1, S2, S3, S4 and SR, which are controlled by the ECM. If an open or short circuit occurs in any of the shift solenoid valves, the ECM controls the remaining normal shift solenoid valves to allow the vehicle to be operated safely. Also, the ECM stops sending current to the open or short circuited solenoid (See page Drivetrain>AB60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM(for 1UR-FE)>FAIL-SAFE CHART).
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0973 | The ECM detects a short in the solenoid valve S1 circuit 2 times when the solenoid valve S1 is operated (1 trip detection logic). | ·
Short in shift solenoid valve S1 circuit ·
Shift solenoid valve S1 ·
ECM |
| P0974 | The ECM detects an open in the solenoid valve S1 circuit 2 times when the solenoid valve S1 is not operated (1 trip detection logic). | ·
Open in shift solenoid valve S1 circuit ·
Shift solenoid valve S1 ·
ECM |
These DTCs indicate an open or short in the shift solenoid valve S1 circuit. When there is an open or short circuit in any shift solenoid valve circuit, the ECM detects the problem, illuminates the MIL and stores the DTC. When the shift solenoid valve S1 is ON, if its resistance is 8 Ω or less, the ECM determines there is a short in the shift solenoid valve S1 circuit.
When the shift solenoid valve S1 is OFF, if its resistance is 100 kΩ or higher, the ECM determines there is an open in the shift solenoid valve S1 circuit (See page Drivetrain>AB60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM(for 1UR-FE)>FAIL-SAFE CHART).
The shift solenoid valve S1 is turned ON/OFF normally when the shift lever is in D:
| ECM gear shift command | 1st | 2nd | 3rd | 4th | 5th | 6th |
| Shift solenoid valve S1 | OFF | ON | ON | ON | ON | ON |
Disconnect the No. 1 transmission wire connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 8 (S1) - Body ground | 20°C (68°F) | 11 to 15 Ω |
| *a | Component without harness connected
(No. 1 Transmission Wire) |
OK
NG
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C45-7 (S1) - Body ground | 20°C (68°F) | 11 to 15 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C46-7 (S1) - Body ground | 20°C (68°F) | 11 to 15 Ω |
| *1 | for LHD |
| *2 | for RHD |
| *a | Front view of wire harness connector
(to ECM) |
OK
NG
OK
NG