The ECM detects the signal from the transfer L4 position switch.
This DTC indicates that the transfer L4 position switch remains on.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| P2772 | The transfer L4 position switch remains on while the vehicle is running under the following conditions for 1.8 sec. or more (1 trip detection logic):
(a) The output shaft speed is between 1000 and 3000 rpm. (b) The transfer position switch is in H4. |
·
Short in transfer L4 position switch circuit ·
4 wheel drive control ECU ·
ECM |
The ECM monitors the transfer-case L4 position switch to determine when the transfer-case L4 gears are engaged. If the L4 switch indicates that the transfer-case L4 gears remain engaged under the following conditions, the ECM will conclude that there is a malfunction of the L4 position switch, illuminate the MIL and store the DTC:
The transfer-case shifter is in the "H4" position.
The transfer-case output shaft rpm is between 1000 and 3000 rpm.
The specified time period has elapsed.
Disconnect the 4 wheel drive control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A27-16 (L4) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector
(to 4 wheel Drive Control ECU) |
OK
(See pageDrivetrain>JF2A (TRANSFER / 4WD / AWD)>TRANSFER SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Disconnect the ECM connector.
Disconnect the A27 4 wheel drive control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A38-21 (L4) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector
(to ECM) |
OK
NG