Use the following procedure listed to troubleshoot the transfer system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Use the GTS to check if the CAN communication system is functioning normally.
for LHD with Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for LHD with Central Gateway ECU)>DIAGNOSIS SYSTEM
for LHD without Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for LHD without Central Gateway ECU)>DIAGNOSIS SYSTEM
for RHD with Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for RHD with Central Gateway ECU)>DIAGNOSIS SYSTEM
for RHD without Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for RHD without Central Gateway ECU)>DIAGNOSIS SYSTEM
The ECU of this system is connected to the CAN communication system.
Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
| Result | Proceed to | |
|---|---|---|
| CAN DTCs are not output | A | |
| CAN DTCs are output | for LHD with Central Gateway ECU | B |
| for LHD without Central Gateway ECU | C | |
| for RHD with Central Gateway ECU | D | |
| for RHD without Central Gateway ECU | E | |
A
B
C
D
E
Check for DTCs.
Click hereDrivetrain>JF2A (TRANSFER / 4WD / AWD)>TRANSFER SYSTEM>DTC CHECK / CLEAR
Check for freeze frame data.
Record or print DTCs and freeze frame data if necessary.
Clear the DTCs and freeze frame data.
Click hereDrivetrain>JF2A (TRANSFER / 4WD / AWD)>TRANSFER SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs.
Click hereDrivetrain>JF2A (TRANSFER / 4WD / AWD)>TRANSFER SYSTEM>DTC CHECK / CLEAR
Simulate the malfunction condition and check if the DTCs are output again.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Refer to Problem Symptoms Table.
Click hereDrivetrain>JF2A (TRANSFER / 4WD / AWD)>TRANSFER SYSTEM>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault not listed in problem symptoms table | A |
| Fault listed in problem symptoms table | B |
A
B
Terminals of ECU.
Click hereDrivetrain>JF2A (TRANSFER / 4WD / AWD)>TRANSFER SYSTEM>TERMINALS OF ECU
Data List / Active Test.
Click hereDrivetrain>JF2A (TRANSFER / 4WD / AWD)>TRANSFER SYSTEM>DATA LIST / ACTIVE TEST
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT