Home › Drivetrain › CLUTCH › CLUTCH PEDAL(for RHD)
RM2660E _52 Drivetrain _052808 CLUTCH _0255311 CLUTCH PEDAL(for RHD) A

CLUTCH  CLUTCH PEDAL(for RHD)  INSTALLATION  


PROCEDURE

Hide 31353 1.INSTALL CLUTCH PEDAL SPRING HOLDER

C358710E01
0.427,1.833 1.802,2.031 1.375,0.198 10 false MP grease

a.

Apply MP grease to the contact surface of the spring holder.


b.

Install the clutch pedal spring holder to the clutch pedal bracket.


Hide 31301C 2.INSTALL CLUTCH PEDAL BUSH

C358711E01
0.406,1.844 1.781,2.042 1.375,0.198 10 false MP grease

a.

Apply MP grease to the inside and outside of 2 new bushes.


b.

Install the 2 bushes to the clutch pedal.


Hide 31324A 3.INSTALL CLUTCH PEDAL SHAFT COLLAR

C358712E01
0.427,1.844 1.802,2.042 1.375,0.198 10 false MP grease

a.

Apply MP grease to the clutch pedal shaft collar.


b.

Install the clutch pedal shaft collar to the clutch pedal.


Hide 31301S 4.INSTALL NO. 2 CLUTCH PEDAL CUSHION

C179832

a.

Install the clutch pedal cushion to the clutch pedal.


Hide 31321 5.INSTALL CLUTCH PEDAL PAD

a.

Install the clutch pedal pad to the clutch pedal.


Hide 31301 6.INSTALL CLUTCH PEDAL SUB-ASSEMBLY

C173234

a.

Install the clutch pedal to the clutch pedal bracket with the nut, washer and bolt.

Torque:
34 N*m (350 kgf*cm, 25 ft.*lbf)

HINT:

Install the bolt from the right side of the vehicle.



Hide 31301A 7.INSTALL CLUTCH PEDAL SPRING

C358713E01
0.385,1.875 1.76,2.073 1.375,0.198 10 false MP grease

a.

Apply MP grease to the pins of the clutch pedal bracket and clutch pedal.


b.

Connect the spring to the clutch pedal, and connect the spring to the clutch pedal bracket with a new E-ring.


Hide 31301R 8.INSTALL TURNOVER SPRING

C358714E01
0.427,1.854 1.802,2.052 1.375,0.198 10 false MP grease

a.

Apply MP grease to the contact surfaces of the spring holder, clutch pedal and spring.


b.

Move the pedal to the full stroke position.


c.

Install the spring to the clutch pedal and spring holder.


Hide 55105D 9.INSTALL CLUTCH PEDAL BRACKET SUB-ASSEMBLY

a.
C173249

Install the clutch pedal bracket to the vehicle, and then temporarily install the bolt.

HINT:

The bolt will be tightened to a torque specification in the "Install Clutch Master Cylinder Assembly" procedure.



b.

Connect the clutch start switch connector.


c.

w/ Cruise Control System:

Connect the clutch switch connector.


Hide 31410 10.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY

a.

Install the clutch master cylinder assembly (See page Drivetrain>CLUTCH>CLUTCH MASTER CYLINDER(for RHD)>INSTALLATION).