Home › Drivetrain › AXLE AND DIFFERENTIAL › STEERING KNUCKLE
RM2660E _52 Drivetrain _052812 AXLE AND DIFFERENTIAL _0255362 STEERING KNUCKLE A

AXLE AND DIFFERENTIAL  STEERING KNUCKLE  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 48826D 1.REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)

Hide 48860D 2.OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)

Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 89543 4.DISCONNECT FRONT SPEED SENSOR LH

a.
C171981

Remove the bolt, skid control sensor clamp and sensor wire.


b.
C171982

Using a 5 mm hexagon socket, remove the bolt and speed sensor from the knuckle.


c.
NOTICE:

Pull out the sensor while trying as much as possible not to rotate it.



Hide 43502C 5.REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH

a.

Remove the front axle hub (See page Drivetrain>AXLE AND DIFFERENTIAL>FRONT AXLE HUB>REMOVAL).


Hide 45047 6.DISCONNECT TIE ROD END SUB-ASSEMBLY LH

a.

Remove the cotter pin and nut.


b.
C179622E01
0.327,2.312 0.712,2.561 0.385,0.248 10 SST 0.686,2.403 1.107,2.403 false 1.107,2.403 1.841,1.67 false

Using SST, disconnect the tie rod end LH from the steering knuckle.

SST
09610-20012  

NOTICE:
·

Do not damage the front disc brake dust cover.

·

Do not damage the ball joint dust cover.

·

Do not damage the steering knuckle.




Hide 48626 7.DISCONNECT FRONT LOWER BALL JOINT ATTACHMENT LH

Hide 43212 8.REMOVE STEERING KNUCKLE LH

a.

Support the front suspension lower arm LH with a jack.


b.

Remove the clip and nut.


c.
C155977E10
2.385,1.385 2.135,1.385 false 2.406,1.313 2.844,1.573 0.438,0.26 10 true SST

Using SST, disconnect the upper ball joint from the steering knuckle.

SST
09628-62011  

NOTICE:

Do not damage the ball joint dust cover.



d.

Remove the steering knuckle.


Hide 43512G 9.REMOVE STEERING KNUCKLE OIL SEAL LH

a.
C179620

Using a screwdriver and hammer, tap out the oil seal.