The suspension control ECU receives signals from the ECM, 4 wheel drive control ECU, skid control ECU (master cylinder solenoid), acceleration sensor (airbag sensor assembly), steering sensor, VGRS ECU (steering control ECU) and main body ECU (multiplex network body ECU) via CAN communication. When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system first.
| DTC Code | Detection Condition | Trouble Area |
|---|---|---|
| U0100 | While driving at 30 km/h (19 mph), CAN communication between the suspension control ECU and ECM stops for 3 seconds or more. | ·
CAN communication system ·
ECM ·
Suspension control ECU |
| U0101 | While driving at 30 km/h (19 mph), CAN communication between the suspension control ECU and ECM stops for 3 seconds or more. | ·
CAN communication system ·
ECM ·
Suspension control ECU |
| U0114 | While driving at 30 km/h (19 mph), CAN communication between the suspension control ECU and 4 wheel drive control ECU stops for 3 seconds or more. | ·
CAN communication system ·
4 wheel drive control ECU ·
Suspension control ECU |
| U0122 | CAN communication between the suspension control ECU and skid control ECU (master cylinder solenoid) stops for 3 seconds or more. | ·
CAN communication system ·
Skid control ECU (master cylinder solenoid) ·
Suspension control ECU |
| U0124 | CAN communication between the suspension control ECU and acceleration sensor (airbag sensor assembly) stops for 3 seconds or more. | ·
CAN communication system ·
Acceleration sensor (airbag sensor assembly) ·
Suspension control ECU |
| U0126 | CAN communication between the suspension control ECU and steering sensor stops for 3 seconds or more. | ·
CAN communication system ·
Steering sensor ·
Suspension control ECU |
| U0130 | 5 seconds after the engine switch is turned on (IG), CAN communication between the suspension control ECU and steering control ECU stops for 3 seconds or more. | ·
CAN communication system ·
VGRS ECU (steering control ECU) ·
Suspension control ECU |
| U0140 | CAN communication between the suspension control ECU and main body ECU (multiplex network body ECU) stops for 5 seconds or more. | ·
CAN communication system ·
Main body ECU (multiplex network body ECU) ·
Suspension control ECU |
Before performing troubleshooting, inspect the connectors of related circuits.
If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (See page Suspension>SUSPENSION CONTROL>ACTIVE HEIGHT CONTROL SUSPENSION>INITIALIZATION).
Clear the DTCs (See page Suspension>SUSPENSION CONTROL>ACTIVE HEIGHT CONTROL SUSPENSION>DTC CHECK / CLEAR).
NEXT
Perform a road test.
Check for DTCs.
DTC is not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for LHD with Central Gateway ECU) | B |
| NG (for RHD without Central Gateway ECU) | C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C