Home › Suspension › SUSPENSION CONTROL › ACTIVE HEIGHT CONTROL SUSPENSION › 2014.08–2015.08
RM2660E _53 Suspension _052813 SUSPENSION CONTROL _0255367 ACTIVE HEIGHT CONTROL SUSPENSION C

SUSPENSION CONTROL  ACTIVE HEIGHT CONTROL SUSPENSION  C1783  Speed Signal Communication Error  


DESCRIPTION

The speed sensors monitor the speed of the wheels, and send appropriate speed signals to the suspension control ECU through the skid control ECU. If trouble occurs in either the front speed sensor or rear speed sensor, DTC (C1783) is output.

DTC Code Detection Condition Trouble Area
C1783 A speed sensor circuit malfunction for 1 second or more.
·

Vehicle stability control system

·

Suspension control ECU



CAUTION / NOTICE / HINT

NOTICE:
·

Before performing troubleshooting, inspect the connectors of related circuits.

·

If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (See page Suspension>SUSPENSION CONTROL>ACTIVE HEIGHT CONTROL SUSPENSION>INITIALIZATION).



PROCEDURE

1.CHECK FOR DTC (VEHICLE STABILITY CONTROL SYSTEM)
a.

Check if a speed sensor malfunction DTC is output under the vehicle stability control system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output B



A

2.CLEAR DTC

B

GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

2.CLEAR DTC

NEXT

3.CHECK DTC
3.CHECK DTC
a.

Check for DTCs.

Result
Result Proceed to
DTC C1783 is output A
DTC C1783 is not output B



A

REPLACE SUSPENSION CONTROL ECU

B