1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
64910J
2.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
3.REMOVE REAR NO. 2 SEAT ASSEMBLY LH (except Face to Face Seat Type)
Remove the rear No. 2 seat assembly LH (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(except Face to Face Seat Type)>REMOVAL).
4.REMOVE REAR NO. 2 SEAT ASSEMBLY RH (except Face to Face Seat Type)
Use the same procedures described for the LH side.
5.REMOVE REAR NO. 2 SEAT ASSEMBLY LH (for Face to Face Seat Type)
Remove the rear No. 2 seat assembly LH (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(for Face to Face Seat Type)>REMOVAL).
6.REMOVE REAR NO. 2 SEAT ASSEMBLY RH (for Face to Face Seat Type)
Use the same procedures described for the LH side.
51775
7.REMOVE REAR STEP COVER
67918E
8.REMOVE REAR DOOR SCUFF PLATE LH
58574A
9.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
64937A
10.REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/ Tonneau Cover)
71845B
11.REMOVE REAR SEAT COVER CAP (w/ Rear No. 2 Seat, except Face to Face Seat Type)
62520P
12.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH
87217E
13.REMOVE REAR SIDE NO. 2 AIR DUCT (w/ Heater)
89293
14.REMOVE SUSPENSION CONTROL ECU
Detach the wire harness clamp and disconnect the connector.
Remove the 2 bolts and ECU.