The steering sensor signal is sent to the suspension control ECU through the CAN communication system. When there is a communication malfunction, it will be detected by the diagnosis function.
| DTC Code | Detection Condition | Trouble Area |
|---|---|---|
| C1784 | A steering angle sensor signal malfunction is detected, or the steering angle sensor power malfunction signal is detected for 5 seconds or more. | ·
Vehicle stability control system ·
Suspension control ECU |
Before performing troubleshooting, inspect the connectors of related circuits.
If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (See page Suspension>SUSPENSION CONTROL>ACTIVE HEIGHT CONTROL SUSPENSION>INITIALIZATION).
Check if a steering sensor malfunction DTC is output under the vehicle stability control system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Clear the DTCs (See page Suspension>SUSPENSION CONTROL>ACTIVE HEIGHT CONTROL SUSPENSION>DTC CHECK / CLEAR).
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC C1784 is output | A |
| DTC C1784 is not output | B |
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)