Home › Suspension › SUSPENSION CONTROL › ACTIVE HEIGHT CONTROL SUSPENSION › from 2015.08
RM2660E _53 Suspension _052813 SUSPENSION CONTROL _0255367 ACTIVE HEIGHT CONTROL SUSPENSION C

SUSPENSION CONTROL  ACTIVE HEIGHT CONTROL SUSPENSION  C1784  Steering Angle Sensor Communication Error  


DESCRIPTION

The steering sensor signal is sent to the suspension control ECU through the CAN communication system. When there is a communication malfunction, it will be detected by the diagnosis function.

DTC Code Detection Condition Trouble Area
C1784 A steering sensor signal malfunction is detected, or the steering sensor power malfunction signal is detected for 5 seconds or more.
·

Vehicle stability control system

·

Suspension control ECU



CAUTION / NOTICE / HINT

NOTICE:
·

Before performing troubleshooting, inspect the connectors of related circuits.

·

If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (See page Suspension>SUSPENSION CONTROL>ACTIVE HEIGHT CONTROL SUSPENSION>INITIALIZATION).



PROCEDURE

1.CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
a.

Check if a steering sensor malfunction DTC is output under the vehicle stability control system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output B



A

2.CLEAR DTC

B

GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

2.CLEAR DTC

NEXT

3.CHECK DTC
3.CHECK DTC
a.

Check for DTCs.

Result
Result Proceed to
DTC C1784 is output A
DTC C1784 is not output B



A

REPLACE SUSPENSION CONTROL ECU

B