Home › Suspension › SUSPENSION CONTROL › ACTIVE HEIGHT CONTROL SUSPENSION › 2014.08–2015.08
RM2660E _53 Suspension _052813 SUSPENSION CONTROL _0255367 ACTIVE HEIGHT CONTROL SUSPENSION C

SUSPENSION CONTROL  ACTIVE HEIGHT CONTROL SUSPENSION  C1787  Forward/Rearward/Sideways G Sensor Communication Error  


DESCRIPTION

The suspension control ECU receives signals from the yaw rate sensor via CAN communication.

DTC Code Detection Condition Trouble Area
C1787 While the engine switch is on (IG), the yaw rate sensor malfunction signal is detected for 1 second or more.
·

Vehicle stability control system

·

Suspension control ECU



CAUTION / NOTICE / HINT

NOTICE:
·

Before performing troubleshooting, inspect the connectors of related circuits.

·

If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (See page Suspension>SUSPENSION CONTROL>ACTIVE HEIGHT CONTROL SUSPENSION>INITIALIZATION).



PROCEDURE

1.CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
a.

Check if a yaw rate sensor malfunction DTC is output under the vehicle stability control system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output B



A

2.CLEAR DTC

B

GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

2.CLEAR DTC

NEXT

3.CHECK DTC
3.CHECK DTC
a.

Check for DTCs.

Result
Result Proceed to
DTC C1787 is output A
DTC C1787 is not output B



A

REPLACE SUSPENSION CONTROL ECU

B