The suspension control ECU receives signals from the acceleration sensor (airbag sensor assembly) via CAN communication.
| DTC Code | Detection Condition | Trouble Area |
|---|---|---|
| C1787 | While the engine switch is on (IG), the acceleration sensor (airbag sensor assembly) malfunction signal is detected for 1 second or more. | ·
Vehicle stability control system ·
Suspension control ECU |
Before performing troubleshooting, inspect the connectors of related circuits.
If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (See page Suspension>SUSPENSION CONTROL>ACTIVE HEIGHT CONTROL SUSPENSION>INITIALIZATION).
Check if a acceleration sensor (airbag sensor assembly) malfunction DTC is output under the vehicle stability control system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Clear the DTCs (See page Suspension>SUSPENSION CONTROL>ACTIVE HEIGHT CONTROL SUSPENSION>DTC CHECK / CLEAR).
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC C1787 is output | A |
| DTC C1787 is not output | B |
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)