Home › Suspension › SUSPENSION CONTROL › ACTIVE HEIGHT CONTROL SUSPENSION › from 2015.08
RM2660E _53 Suspension _052813 SUSPENSION CONTROL _0255367 ACTIVE HEIGHT CONTROL SUSPENSION C

SUSPENSION CONTROL  ACTIVE HEIGHT CONTROL SUSPENSION  C1794  Height Control OFF Switch Circuit (Test Mode DTC)  


DESCRIPTION

When the height control switch OFF (integration control and panel assembly) is pushed and height control turns off.

The off condition of the height control will not be canceled until the height control OFF switch is pushed again or the vehicle is driven.

DTC Code Detection Condition Trouble Area
C1794 The test mode procedure is performed.
·

Harness or connector

·

Height control OFF switch (integration control and panel assembly)

·

Suspension control ECU



WIRING DIAGRAM

C177227E17
1.396,1.417 4.344,1.885 2.948,0.469 10 false Height Control OFF Switch (Integration Control and Panel Assembly) 5.688,0.688 5.969,0.885 0.281,0.198 10 false TD 5.365,0.583 5.635,0.875 0.271,0.292 10 false 11 5.24,1.76 6.885,2.021 1.646,0.26 10 false Suspension Control ECU 2.021,0.688 2.406,0.865 0.385,0.177 10 false E 3.125,0.708 3.333,0.875 0.208,0.167 10 false N 5.24,1.604 5.573,1.781 0.333,0.177 10 false K34 1.417,1.229 1.615,1.375 0.198,0.146 10 false V8 1.677,0.594 1.875,0.76 0.198,0.167 10 false 10 3.417,0.542 3.531,0.708 0.115,0.167 10 false 7

CAUTION / NOTICE / HINT

NOTICE:
·

Before performing troubleshooting, inspect the connectors of related circuits.

·

If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (See page Suspension>SUSPENSION CONTROL>ACTIVE HEIGHT CONTROL SUSPENSION>INITIALIZATION).



PROCEDURE

1.INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY
a.

Remove the height control OFF switch (integration control and panel assembly) (See page Suspension>SUSPENSION CONTROL>ABSORBER CONTROL SWITCH>REMOVAL).


b.

Inspect the height control OFF switch (integration control and panel assembly) (See page Suspension>SUSPENSION CONTROL>ABSORBER CONTROL SWITCH>INSPECTION).



OK

2.CHECK HARNESS AND CONNECTOR (SUSPENSION CONTROL ECU - INTEGRATION CONTROL AND PANEL ASSEMBLY AND BODY GROUND)

NG

REPLACE INTEGRATION CONTROL AND PANEL ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (SUSPENSION CONTROL ECU - INTEGRATION CONTROL AND PANEL ASSEMBLY AND BODY GROUND)
a.

Disconnect the K34 suspension control ECU connector.


b.

Disconnect the V8 height control OFF switch (integration control and panel assembly) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K34-11 (TD) - V8-7 (N) Always Below 1 Ω
K34-11 (TD) or V8-7 (N) - Body ground Always 10 kΩ or higher
V8-10 (E) - Body ground Always Below 1 Ω




OK

REPLACE SUSPENSION CONTROL ECU

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR