Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1. SUSPENSION FLUID PRESSURE RELEASE
2.REMOVE SIDE STEP ASSEMBLY LH
489B0
3.REMOVE HEIGHT CONTROL PROTECTOR PIPE
Remove the 6 bolts and protector pipe.
489D0
4.REMOVE HEIGHT CONTROL CYLINDER BRACKET ASSEMBLY
Remove the 6 bolts and 3 brackets from the frame.
5.DISCHARGE SUSPENSION FLUID PRESSURE
Connect a hose to the bleeder plug for the shock absorber control valve and loosen the bleeder plug.
Discharge the suspension fluid pressure.
After the fluid pressure has dropped and oil has drained out, tighten the bleeder plug and remove the hose.
48991A
6.REMOVE NO. 1 HEIGHT CONTROL TUBE LH
Remove the union bolt and gasket from the front No. 1 accumulator.
Using a union nut wrench, remove the No. 1 control tube from the shock absorber control valve.
49140
7.REMOVE FRONT NO. 1 SUSPENSION CONTROL ACCUMULATOR ASSEMBLY LH
Using SST, remove the nut, washer and front No. 1 suspension control accumulator from the bracket.
Remove the 2 bolts and front No. 1 suspension control accumulator bracket from the frame.
49147D
8.REMOVE FRONT NO. 2 SUSPENSION CONTROL ACCUMULATOR LH
Remove the No. 2 control accumulator and O-ring from the front shock absorber control valve.
48992
9.REMOVE NO. 2 HEIGHT CONTROL TUBE LH
Using a union nut wrench, disconnect the No. 2 control tube from the No. 3 height control tube, shock absorber control valve and control valve.
Remove the bolt and No. 2 control tube.
49162B
10.DISCONNECT NO. 2 SUSPENSION CONTROL PRESSURE HOSE
Remove the union bolt and gasket, then disconnect the No. 2 pressure hose from the shock absorber control valve.
48020B
11.REMOVE FRONT SHOCK ABSORBER CONTROL VALVE ASSEMBLY LH
Disconnect the connector.
Remove the 3 bolts and control valve.
Remove the cap and bleeder plug.
49141D
12.REMOVE FRONT NO. 3 SUSPENSION CONTROL ACCUMULATOR LH
Remove the control accumulator from the control valve.
Remove the O-ring and back-up ring from the accumulator.
49020
13.REMOVE FRONT SUSPENSION CONTROL VALVE ASSEMBLY LH
Disconnect the connector from the control valve.
Remove the 3 bolts and control valve.