Home › Suspension › FRONT SUSPENSION › FRONT UPPER SUSPENSION ARM
RM2660E _53 Suspension _052815 FRONT SUSPENSION _0255384 FRONT UPPER SUSPENSION ARM A

FRONT SUSPENSION  FRONT UPPER SUSPENSION ARM  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 48826D 1.REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)

Hide 48860D 2.OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)

Hide 3.REMOVE FRONT WHEEL

Hide 89406 4.REMOVE FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Active Height Control)

Hide 89516 5.DISCONNECT SKID CONTROL SENSOR WIRE

C173472E05
0.948,0.354 0.698,0.354 0.698,0.354 0.698,1.083 true 0.594,2.542 0.354,2.542 0.354,2.542 0.354,3.865 true 0.99,0.271 1.917,0.604 0.927,0.333 10 true Upper Arm 0.625,2.438 1.771,2.823 1.146,0.385 10 true Steering Knuckle

a.

Remove the bolt and nut, and disconnect the sensor wire from the steering knuckle and suspension upper arm.


Hide 43212 6.DISCONNECT STEERING KNUCKLE LH

a.
C178724

Support the front suspension lower arm LH with a jack.


b.

Remove the clip and the nut.


c.
C155977E09
2.125,1.354 2.344,1.354 true 2.385,1.292 2.708,1.625 0.323,0.333 10 true SST

Using SST, disconnect the upper ball joint from the steering knuckle.

SST
09628-62011  

NOTICE:

Do not damage the ball joint dust cover.



Hide 53783 7.REMOVE FRONT FENDER APRON TRIM PACKING B (w/ KDSS)

C173475

a.

Using a clip remover, remove the 3 clips and apron trim packing.


Hide 53783 8.REMOVE FRONT FENDER APRON TRIM PACKING B (w/o KDSS)

a.
C173474

Using a clip remover, remove the 4 clips and apron trim packing.


Hide 53785B 9.REMOVE FRONT FENDER APRON TRIM PACKING D

C178878

a.

Using a clip remover, remove the 4 clips and apron trim packing.


Hide 48630 10.REMOVE FRONT SUSPENSION UPPER ARM ASSEMBLY

C173477

a.

Remove the nut, bolt, 2 washers and suspension upper arm.