Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER › from 2015.08
RM2660E _53 Suspension _052817 TIRE PRESSURE MONITORING _0255399 TIRE PRESSURE WARNING RECEIVER A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RECEIVER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 62510P 3.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

Hide 89760C 4.REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER

a.
C339773E02
1.115,0.594 1.25,0.594 1.25,0.594 1.396,1.219 true 1.188,2.573 1.323,2.573 1.323,2.573 1.531,2.177 true 0.844,0.479 1.083,0.729 0.24,0.25 10 true *a 0.948,2.479 1.156,2.688 0.208,0.208 10 true *b

Remove the bolt.


b.

Detach the guide and clamp to remove the tire pressure warning ECU and receiver.

Text in Illustration
*a Guide
*b Clamp


c.

Disconnect the connectors from the tire pressure warning ECU and receiver.