Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › 2014.08–2015.08
RM2660E _53 Suspension _052817 TIRE PRESSURE MONITORING _0255402 TIRE PRESSURE WARNING SYSTEM J

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  ECU Power Source Circuit  


DESCRIPTION

This is the power source for the tire pressure warning ECU and receiver.

WIRING DIAGRAM

C249284E14
4.094,2.208 4.948,2.406 0.854,0.198 10 false L60 4.083,2.406 6.75,2.656 2.667,0.25 10 false Tire Pressure Warning ECU and Receiver 5.083,0.635 5.417,0.865 0.333,0.229 10 false IG1 5.083,1.698 5.458,1.906 0.375,0.208 10 false GN1 4.823,0.479 4.969,0.729 0.146,0.25 10 false 1 4.813,1.563 4.948,1.781 0.135,0.219 10 false 4 3.135,0.823 4.063,1.063 0.927,0.24 10 false ECU-IG No. 4 0.958,0.635 1.938,0.865 0.979,0.229 10 false from IG Circuit

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

·

It is necessary to perform initialization (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.



HINT:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU AND RECEIVER - BATTERY AND BODY GROUND)
a.
U165432E02
0.708,0.583 0.875,0.583 0.875,0.583 0.885,1.031 true 0.875,1.406 0.875,1.781 true 0.438,0.5 0.698,0.667 0.26,0.167 10 false IG1 0.094,0.021 0.344,0.208 0.25,0.188 10 false *a 0.698,1.844 1.031,2 0.333,0.156 10 false GN1 1.573,0.5 1.917,0.667 0.344,0.167 10 false L60

Disconnect the tire pressure warning ECU and receiver L60 connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
L60-1 (IG1) - Body ground Engine switch on (IG) 10 to 16 V
Engine switch off Below 1 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L60-4 (GN1) - Body ground Always Below 1 Ω


Text in Illustration
*a Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)



OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR