Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND DECELERATION SENSOR (w/ VSC) › from 2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255408 YAW RATE AND DECELERATION SENSOR(w/ VSC) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  YAW RATE AND DECELERATION SENSOR(w/ VSC)  INSTALLATION  


PROCEDURE

Hide 89183A 1.INSTALL YAW RATE SENSOR

a.

Connect the sensor connector, and then attach the clamp to the hole of the sensor bracket.

NOTICE:

Securely connect the connector.



b.

Install the yaw rate sensor with the 2 bolts.

Torque:
15 N*m (148 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Make sure that the sensor is oriented correctly.

·

If the sensor is dropped, replace it.

·

When installing the sensor, make sure to avoid impacts to the sensor.

C177095E01
0.09,0.037 0.760,0.242 0.670,0.205 12 for LHD:

C170924E01
0.093,0.071 0.770,0.250 0.677,0.179 12 for RHD:




Hide 88520 2.INSTALL COOLING BOX ASSEMBLY (w/ Cool Box)

Hide 58901A 3.INSTALL REAR CONSOLE BOX SUB-ASSEMBLY (w/o Cool Box)

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 89183A 5.PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION

a.

Perform the yaw rate sensor zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


Hide 89183A 6.CHECK YAW RATE SENSOR SIGNAL