Home › Vehicle Interior › INTERIOR PANELS / TRIM › FRONT CONSOLE BOX(w/ Cool Box) › 2015.08–2016.08
RM2660E _58 Vehicle Interior _052849 INTERIOR PANELS / TRIM _0255721 FRONT CONSOLE BOX(w/ Cool Box) A

INTERIOR PANELS / TRIM  FRONT CONSOLE BOX(w/ Cool Box)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for LHD and RHD vehicles.

·

The procedures listed below are for LHD vehicles.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 88520 1.INSTALL COOLING BOX ASSEMBLY

B182475

a.

Attach the 2 claws.


b.

Connect the connector.


c.

Sufficiently apply compressor oil to 2 new O-rings.

Compressor oil:

ND-OIL 8 or equivalent



d.

Install the 2 O-rings on the 2 cooler pipes.


e.

Connect the 2 cooler pipes with the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


f.

Install the cooling box assembly with the 4 bolts and 2 screws.


Hide 88891H 3.INSTALL NO. 1 COOLER COVER

a.
B183312

Attach the claw on the upper part of the cooler cover, and then attach the clamp on the lower part of the cooler cover to install it.


Hide 58805C 5.INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY

Hide 55406B 8.INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 55402C 10.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

Hide 55448A 11.INSTALL NO. 1 INSTRUMENT PANEL FINISH CUSHION

Hide 55403C 12.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

Hide 55449C 13.INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

Hide 71200S 14.INSTALL FRONT SEAT ASSEMBLY LH (for Manual Seat)

Hide 71200S 15.INSTALL FRONT SEAT ASSEMBLY LH (for Power Seat)