Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (- ) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
89245B
3.REMOVE STEERING SENSOR
Disengage the 6 claws and 2 pins, and remove the steering sensor from the spiral cable sub-assembly.
Do not damage the claws and pins of the spiral cable sub-assembly.