Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE › from 2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255605 SPIRAL CABLE A

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (- ) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 45100 4.REMOVE STEERING WHEEL ASSEMBLY

Hide 5.REMOVE LOWER STEERING COLUMN COVER

Hide 45286B 6.REMOVE UPPER STEERING COLUMN COVER

Hide 7.REMOVE SPIRAL CABLE SUB-ASSEMBLY

a.

Disconnect each connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



b.
B427371

Detach the 3 claws and remove the spiral cable sub-assembly.


Hide 8.REMOVE SPIRAL CABLE (w/ Steering Angle Sensor)

NOTICE:
·

Remove the spiral cable from the steering sensor only when replacing it.

·

Removing the steering sensor from the spiral cable sub-assembly without using a lock pin may result in a misaligned center position of the steering sensor. Therefore, make sure to use the lock pin provided with a new spiral cable when removing the steering sensor from the spiral cable sub-assembly.



a.

Install the lock pin to the steering sensor.

NOTICE:
·

Use the lock pin provided with a new spiral cable.

·

Do not remove the lock pin before the spiral cable is installed to the steering sensor.



B420311


b.
B420310

Detach the 6 claws and remove the spiral cable from the steering sensor.